Research reference · 10 mg vial

AOD-9604 (10 mg Vial) Dosage Protocol

AOD-9604 is dosed at 300 mcg–500 mcg daily via subcutaneous injection in educational protocols. A 10 mg vial reconstituted with bacteriostatic water yields about 3.333 mg/mL. This information is for research and educational use only.

On this page
  1. Quick reference
  2. Dosage chart and four steps
  3. Supplies needed
  4. Vial and research context
  5. Protocol Overview
  6. Dosing Protocol
  7. Storage Instructions
  8. AOD-9604 10 mg Dosage: Calculation and Evidence
  9. A Growth Hormone Fragment, Not Full-Length Growth Hormone
  10. Human Findings and Subcutaneous Safety Limits
  11. How to Compare AOD-9604 Studies
  12. Reconstitution and U-100 Measurement Checks
  13. Important Note
  14. References
  15. Related research, protocols, and guides

AOD-9604 Quick Reference (10 mg Vial)

Vial contents
10 mg AOD-9604
Final volume
3 mL
Concentration
3.33 mg/mL
One U-100 unit
33.33 mcg in 0.01 mL
AOD-9604 (10 mg Vial) Dosage Protocol peptide vial

Research context: For evidence on mechanisms, human and preclinical research, limitations, and safety, read AOD-9604 Peptide: Benefits, Uses, Side Effects, Dosage, and Research.

AOD-9604 Dosage Chart

Dosing & Reconstitution Guide

Educational guide for reconstitution and daily dosing

Standard / Gradual Approach (3 mL = ~3.333 mg/mL)

Week Daily Dose (mcg) Units (per injection) (mL)
Weeks 1–4 300 mcg 9 units (0.09 mL)
Weeks 5–12 500 mcg 15 units (0.15 mL)

Frequency: Inject once daily subcutaneously (typically in the morning on an empty stomach). This schedule uses the largest practical dilution (3.0 mL). For the 9-unit measurement, consider a 30- or 50-unit insulin syringe for improved readability. Rotate injection sites (abdomen, thighs, upper arms) to minimize local irritation.

Reconstitution Steps

  1. Draw 3.0 mL bacteriostatic water with a sterile syringe.
  2. Inject slowly down the vial wall; avoid foaming.
  3. Gently swirl/roll until dissolved (do not shake).
  4. Label and refrigerate at 2–8 °C (35.6–46.4 °F), protected from light.

Storage note: These temperatures are general laboratory handling guidance, not a validated use-by period for this AOD-9604 preparation. Follow the exact product instructions if they differ.[17][19]

Important: This guide is for educational purposes only and is not medical advice. For research use only. Not for human consumption.

Supplies Needed

Plan based on an 8–12 week daily protocol with gradual titration (300 mcg Weeks 1–4, 500 mcg Weeks 5+).

  • Peptide Vials (AOD-9604, 10 mg each):
    • 8 weeks: approximately 3 vials required
    • 12 weeks: approximately 4 vials required
  • Insulin Syringes (U‑100):
    • Per week: 7 syringes (1/day)
    • 8 weeks: 56 syringes
    • 12 weeks: 84 syringes
  • Bacteriostatic Water (10 mL bottles): Use 3.0 mL per vial for reconstitution.
    • 8 weeks (3 vials): 9 mL - 1 bottle required (10 mL each)
    • 12 weeks (4 vials): 12 mL - 2 bottles required (10 mL each)
  • Alcohol Swabs: One for the vial stopper + one for the injection site each day.
    • Per week: 14 swabs (2/day)
    • 8 weeks: 112 swabs - 2 boxes required (100 swabs each)
    • 12 weeks: 168 swabs - 2 boxes required (100 swabs each)
AOD-9604 10 mg

AOD-9604 10 mg

View Supplier
U-100 syringes

U-100 syringes

View Supplier
Bacteriostatic water

Bacteriostatic water

View Supplier
Alcohol swabs

Alcohol swabs

View Supplier

AOD-9604 Vial and Research Context

  • Reconstitute: Add 3.0 mL bacteriostatic water → ~3.333 mg/mL (3333 mcg/mL) concentration.
  • Daily range: 300–500 mcg once daily (gradual titration).
  • Easy measuring: At 3.333 mg/mL, 1 unit = 0.01 mL ≈ 33.33 mcg on a U‑100 insulin syringe.
  • Storage (general laboratory handling): Lyophilized: freeze at −20 °C (−4 °F); after reconstitution, refrigerate at 2–8 °C (35.6–46.4 °F); avoid freeze–thaw cycles. See the formulation limits in Storage Instructions below.[17]

AOD-9604 is a modified fragment based on the C-terminal region of human growth hormone. Animal research investigated its effects on lipid metabolism.[1][4] Human safety findings summarized oral and intravenous studies; they do not establish a placebo-like safety profile for subcutaneous administration of this 10 mg vial preparation.[2] FDA’s 2024 review found no human subcutaneous clinical data and insufficient evidence of effectiveness for obesity.[3]

Protocol Overview

Concise summary of the once‑daily regimen.

  • Goal: Support reduction of fat mass and enhance fat oxidation over time[1][4].
  • Schedule: Daily subcutaneous injections for 8–12 weeks.
  • Dose Range: 300–500 mcg daily with gradual titration.
  • Reconstitution: 3.0 mL per 10 mg vial (~3.333 mg/mL) for accurate unit measurements.
  • Storage (general laboratory handling): Lyophilized frozen; reconstituted refrigerated; avoid repeated freeze–thaw. Product-specific directions take precedence.[17]

Dosing Protocol

Suggested daily titration approach.

  • Start: 300 mcg daily for Weeks 1–4; increase to 500 mcg for Weeks 5–12 as tolerated.
  • Target: 500 mcg daily by Week 5 and maintain through cycle completion.
  • Frequency: Once per day (subcutaneous).
  • Cycle Length: 8–12 weeks.
  • Timing: Morning administration (fasted) is common; rotate injection sites.

Storage Instructions

General peptide guides provide a laboratory handling reference, not a validated shelf life for this AOD-9604 10 mg preparation. The exact product’s documented instructions take precedence.

  • Dry powder: Keep lyophilized peptide tightly capped and dry. General laboratory guidance uses a freezer at −4 °F (−20 °C) for frozen storage and advises avoiding repeated freeze–thaw cycles.[17]
  • After mixing: Sigma’s general peptide guide describes short-term refrigeration around 39 °F (4 °C), within the refrigerated range shown above. This is not a guarantee of stability for every peptide solution. Keep the vial capped and avoid repeated freeze–thaw cycles.[17]
  • Light and handling: Protect laboratory peptide preparations from direct light and minimize unnecessary handling.[18]

No validated use-by period is assigned here. Stability testing needs to match the actual formulation and reconstituted concentration. Refrigeration and bacteriostatic water do not establish this vial’s potency, sterility or a 28-day usable life.[19]

AOD-9604 10 mg Dosage: Calculation and Evidence

AOD-9604 10 mg dosage arithmetic depends on both vial mass and final volume. With 10 mg in 3 mL, the calculated concentration is about 3.333 mg/mL. At that concentration, each U-100 unit contains about 33.33 mcg.

AOD 9604 dosage calculations cannot establish a treatment protocol. The human safety literature summarized oral and intravenous studies. Those findings do not validate subcutaneous administration of a commercially supplied vial.[2][3]

A Growth Hormone Fragment, Not Full-Length Growth Hormone

AOD-9604 is a modified fragment based on the C-terminal region of human growth hormone. Researchers investigated its metabolic effects, but the fragment’s proposed actions should not be treated as the established actions of full-length growth hormone.[1]

In obese mice and mice lacking the beta-3 adrenergic receptor, investigators examined lipid metabolism and the receptor’s role in the response. That experiment provides animal-model evidence, not proof that an AOD-9604 injection produces weight loss in people.[4]

Human Findings and Subcutaneous Safety Limits

The 2013 human safety report summarized six randomized trials involving oral or intravenous AOD-9604. It reported no significant increase in IGF-I and generally similar adverse-event findings between study groups under those tested conditions. It did not establish a safety profile for this subcutaneous preparation.[2]

FDA’s 2024 compounding review found no human subcutaneous clinical data and insufficient evidence of effectiveness for obesity. A selected result from an earlier trial cannot resolve those broader limitations.[3]

FDA also identifies limited safety information, possible immunogenicity and impurity-related concerns, and serious adverse events that may be associated with AOD-9604. The agency notes that causality is unclear. That is a reason for caution, not proof that every reported event was caused by the compound.[15]

How to Compare AOD-9604 Studies

Check the route before interpreting a result. Oral exposure, intravenous exposure, and a subcutaneous vial protocol are different interventions. The measured endpoint matters too: a safety study is not automatically a demonstration of weight-loss effectiveness.[2][3]

Descriptions such as fat breakdown or metabolic support can summarize a research question. They should not turn a proposed mechanism into a promised result for the person reading a dosage chart.

Reconstitution and U-100 Measurement Checks

U-100 units are volume markings, not peptide international units. One unit is 0.01 mL. A concentration belongs to a particular final volume, so the same syringe marking will contain a different mass after a different dilution.

Check the syringe’s capacity and graduations separately from the device used to measure the full preparation volume. A vial’s nominal capacity does not independently verify solubility, sterile preparation, or compatibility with bacteriostatic water.

CDC’s general injection-safety guidance calls for new sterile equipment when accessing a vial and disposal of used needles and syringes. It does not approve an AOD-9604 formulation or protocol.[16]

Important Note

This dosage chart provides educational calculations and research context. It does not establish the safety or effectiveness of AOD-9604 for human use or replace medical assessment.

References

  • 1

    Journal of Endocrinology and Metabolism (2014)
    : Safety and metabolism of AOD9604 as a nutraceutical ingredient; mechanism of action and metabolic studies
  • 2

    Journal of Endocrinology and Metabolism (2013)
    : Safety and tolerability of AOD9604 in humans; no IGF‑1 increase; placebo‑like safety profile
  • 3

    FDA Pharmacy Compounding Advisory Committee (2024)
    : AOD‑9604 bulk drug substance meeting memorandum; regulatory and safety overview
  • 4

    Endocrinology (OUP)
    : Effects of hGH and AOD9604 on lipid metabolism in obese mice; β‑adrenergic pathway mechanisms
  • 15
    FDA: AOD-9604 compounding safety concerns and evidence limitations
  • 16
    CDC: Safe injection practices and vial-access equipment
  • 17
    MilliporeSigma: Handling Storage, general laboratory guidance for lyophilized peptides and peptide solutions; not an AOD-9604 product stability study
  • 18
    Thermo Fisher Scientific: Standard Peptide Custom Synthesis Service, general storage and handling guidance; solution stability depends on the peptide
  • 19
    FDA: Lyophilization of Parenteral (7/93), product-specific reconstitution stability and sterility-testing considerations